RCA Victor 45 RPM Record Player Phono Cartridge for Model 45-EY-4

Description

It's time to dig out those old 45's
and have a party with
The Redhead
On your Classic
RCA Victor
45 RPM Record Player
Ever since we introduced our replacement idler wheel,
the
only one
available featuring a genuine Oilite bearing for
superior performance and precision made for the Classic
RCA Victor RP -168 & RP-190 45 RPM Automatic
Record Changers, many of our customers have requested,
and a few demanded, that we design and manufacture the
highest quality replacement cartridge.
The
REDHEAD
Cartridge is now available!
Step One
We pre-test every cartridge for sound quality and output in
our Blue-Arm test jig featuring a custom made plug-in tone-arm.
Step Two
We believe that soldering output leads to a cartridge is an unprofessional shortcut.
The amount of heat necessary to insure a good connection creates the risk of damage
to the cartridge with degraded sound quality that may show up now or later.
We assemble precision connectors and install using no heat.
Step Three
The cartridge mounting angle was confirmed by comparing to a
commercial turntable by Innotech that uses the identical cartridge.
Step Four
Every completed Redhead cartridge is tested for
exceptional performance in our Clear-Arm test jig
Step Five
Installation Instructions
The RCA 45 player must be in good condition.
The idler wheel, rubber motor mounts and cycle cam need to be checked
and replaced as necessary. The tone arm must move freely with no binding.
Clean and lubricate the motor to insure correct speed.
1
) Please handle the
"Redhead"
cartridge carefully.
2)
Remove the old cartridge
3)
Install
"Redhead"
cartridge using the old screws and new washers supplied.
4)
Reattach leads, positive side
(+)
is identified with a red dot on cartridge.
5)
The ground or third wire is not necessary, tape off or remove.
6)
Adjust the correct tone-arm landing by referring to the instructions on the enclosed CD
7)
The conversion cartridge weighs just about the same as the original cartridge however
you may need to "fine-tune" the counterbalance for best performance.
8)
This cartridge is rated for 2 to 4 grams of pressure. We have found that 4 grams provides
excellent tracking in our test jig.
Typical installation in RCA RP-190 Tone Arm
Typical installation in RCA RP-168 Tone Arm
Just to be sure your RCA 45 changer is assembled and adjusted correctly
we will include with your
Redhead
Conversion Kit a data CD with complete
service and adjustment information for both the RP-168 and RP-190 changers
"No questions asked" Guarantee
If for any reason you are not thrilled with the performance of
The Redhead Tone-Arm Cartridge
just send it back for a full refund
"No Questions Asked"